Dan Kaplan
06-17-2000, 03:37 PM
If anyone is familiar with the two programs mentioned in the subject, I would be very appreciative if you could help me with a little setup question.
It's a long story... in a nutshell, I am currently using Outlook Express for my FQ POP (sounds like a marketable beverage :) ) accounts, but need to switch over to Outlook.[nbsp][nbsp]In OE, I have two "identities" set up, one for run-down.com and one for abledesign.com.[nbsp][nbsp]The two are separate from each other, different login, inbox, sig file, etc.
In Outlook, I can't find any option for doing something similar.[nbsp][nbsp]I can set up both POP accounts, but I see no option for separating them???[nbsp][nbsp]They share the inbox, address book, and sig file.[nbsp][nbsp]If I send a test message to either of them and reply, the reply comes from which ever of the two email addresses I sent it to.[nbsp][nbsp]That's good.[nbsp][nbsp]But if I send a new message from within Outlook, it sends it from which ever of the two accounts is the default.[nbsp][nbsp]That's bad.[nbsp][nbsp]Surely there is some way of doing this?[nbsp][nbsp]I see no mention of how to do this in the help files.
Thanks in advance,
Duplicity
It's a long story... in a nutshell, I am currently using Outlook Express for my FQ POP (sounds like a marketable beverage :) ) accounts, but need to switch over to Outlook.[nbsp][nbsp]In OE, I have two "identities" set up, one for run-down.com and one for abledesign.com.[nbsp][nbsp]The two are separate from each other, different login, inbox, sig file, etc.
In Outlook, I can't find any option for doing something similar.[nbsp][nbsp]I can set up both POP accounts, but I see no option for separating them???[nbsp][nbsp]They share the inbox, address book, and sig file.[nbsp][nbsp]If I send a test message to either of them and reply, the reply comes from which ever of the two email addresses I sent it to.[nbsp][nbsp]That's good.[nbsp][nbsp]But if I send a new message from within Outlook, it sends it from which ever of the two accounts is the default.[nbsp][nbsp]That's bad.[nbsp][nbsp]Surely there is some way of doing this?[nbsp][nbsp]I see no mention of how to do this in the help files.
Thanks in advance,
Duplicity